November 22, 2026

The Quest for the Perfect Pocket eReader: Modding the Onyx Boox Picco for MagSafe Compatibility

In the rapidly evolving landscape of E Ink technology, Onyx Boox has carved out a reputation for producing some of the most versatile and high-performing devices available. For those who prioritize portability and specialized reading experiences, the brand has often been the gold standard. However, even the most premium hardware can sometimes be let down by its ecosystem—or lack thereof. Such is the case with the Boox Picco, a miniature eReader that occupies a unique niche in the market but recently lost its most valuable accessory: the official MagSafe-compatible case.

The Boox Picco is a marvel of miniaturization, designed specifically for readers who find traditional 6-inch or 7-inch tablets too cumbersome for a daily commute or a quick reading session during a lunch break. It is a device built for the pocket, weighing a mere 58 grams, making it lighter than almost any modern smartphone. Its matte, slightly grainy back panel suggests a device meant to be held, yet its small stature also makes it the perfect candidate for magnetic mounting. For a brief period, Onyx Boox sold a dedicated MagSafe case for the Picco, allowing users to snap the reader onto the back of a phone or a magnetic stand. When that case was quietly pulled from the shelves, it left a significant gap in functionality that third-party manufacturers have yet to fill.

Faced with the disappearance of the official solution, the challenge became clear: if the manufacturer won’t provide the magnetic utility this device deserves, it must be added manually. The goal was to integrate MagSafe functionality without compromising the Picco’s signature lightness or its ergonomic appeal. As it turns out, the path to a DIY MagSafe eReader is paved with trial, error, and a deep dive into the physics of rare-earth magnets.

I put a magnetic plate on my Boox Picco to make it MagSafe

Finding the Right Magnet for the Job

The initial phase of any hardware modification involves sourcing components that balance strength with aesthetics. On the surface, adding a magnetic element to a device seems straightforward. The market is saturated with adhesive magnetic rings designed for iPhones and Android devices, typically intended to be stuck onto the back of a non-magnetic phone case. However, the requirements for the Boox Picco were inverted.

Most "MagSafe adapters" sold on platforms like Amazon or Best Buy are actually thin metal rings, not magnets themselves. They are designed to provide a ferrous surface for a MagSafe charger or mount to grab onto. To make the Picco stick to a smartphone—which itself contains the magnetic array—the reader needed an actual magnetized surface, not just a piece of metal. This distinction is where many DIY projects falter.

The Limits of Standard Adhesive Magnets

The search began in the craft and office supply sector. The first attempt involved a standard, flat, round magnetic sticker backed with 3M adhesive. These are ubiquitous in classrooms and offices, commonly used to turn lightweight photos or cards into fridge magnets. Given that the Boox Picco weighs only 58 grams—roughly a quarter of the weight of a premium smartphone like the Pixel 10 Pro—the assumption was that a basic craft magnet would provide sufficient pull.

The reality was disappointing. While the 3M adhesive bonded perfectly to the Picco’s textured back, the magnetic flux of the craft sticker was simply too weak. When placed against the back of a Pixel 10 Pro, the reader would slowly slide down or detach at the slightest tilt. It became evident that supporting even a featherweight device requires a more sophisticated magnetic solution. The project required a move away from flexible ferrite magnets and toward the powerhouse of the magnet world: neodymium.